J1772 Active Vehicle Control Module AVC2.r

This control module handles the pilot and proximity signals. This is required to use public J1772 Level 1 and Level 2 charging stations. Additionally, the module has a NO and NC relay which can be used to cut power to the driving system while charging. This can prevent you from driving away while the charging plug is still connected. There are 8 connections and the module is powered by the vehicle's 12-volt system, current draw is always under 20ma. If you're looking for the J1772 charge port as well you can find it here.

The AVC2.r already has a 2.74k Ohm resistor between the proximity and ground built-in. If your system already has this resistor between proximity and ground you will need the AVC2.

Connections on the AVC2.r

Relay NO - Normally Open
Relay C - Common
Relay NC - Normally Closed
+12 power from the vehicle
CH chassis ground (and AC power ground)
GND green wire from J1772 Inlet Connector
PROX prox wire from J1772 Inlet Connector
PILOT pilot wire from J1772 Inlet Connector